Precautions when using

Do not burn enamel products empty! Because rapid heating will crack the surface vitreous, frying and frying in the state of high temperature dry burning should be avoided as much as possible.
If direct fire is used, it is necessary to avoid the furnace fire being larger than the range of the bottom of the enamel.
When filling with hot water or heating, the handle will also conduct heat, so you need to pay more attention.
The enamel products are all ironware coated with enamel protective layer, so please do not hit hard to avoid the enamel layer falling off and causing rust.
Do not allow moisture to stay in the enamelware for a long time.
During the production process of enamel products, there may be a thin glaze on the edge of the vessel or the spout, and there may also be small black spots that are not glazed due to the traces of hanging the vessel upside down and placing it during firing. These are normal phenomena and do not belong to the scope of defect determination.

Precautions when cleaning

Enamel material, not easy to absorb smell, good heat preservation, and easy to clean. Please use a sponge or soft cotton cloth to clean the cleaning method to prevent scratching the surface of the product. Remember not to use cleaning towels, wire brushes, etc. to clean, because it will definitely scratch the surface of the product.

After cleaning, please keep the product dry at any time, wipe it with a dry cloth, pay attention to the product bending parts must be kept dry to prevent rust, so that the product can be used for a longer time.

Precautions when receiving

Store in a ventilated and dry place to avoid moisture and rust.

Enamel pot burnt treatment

Pour warm water into the pot.
Add 1 tablespoon of baking soda and mix well.
Add a small amount of cooking oil (2,3 drops).
Turn on the heat and turn off the heat when the water in the pot boils.
Continue to stand for a few hours, pour off the water after cooling, and wash carefully with a sponge.

※If the burnt condition is serious, please repeat the above steps.